INFOSEC UPS SYSTEM 66085, Руководство пользователя

Страница: 10 / 43

INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 07 19 AA 36 205 08
10
1 0 . I N D I C A T O R S & A L A R M S
LED Alarm Condition
On Off Normal
Flash
Beep 1 time In Every 30
Seconds
Utility Failure - The UPS is providing battery power to
protected UPS outlets.
Flash
Beep 1 time In Every 2
Seconds
Utility Failure - The UPS is providing battery power. The
rapid
beeps indicate the battery will run out of power shortly.
On/Flash
Beep 1 time In Every 0.5
Second
Overload - Occurs when connected equipment exceeds the
rating of the unit. Turn the UPS off and unplug at least one
piece of equipment from the UPS.
1 1 . T R O U B L E S H O O T I N G
Should the UPS fail to function correctly we recommend you perform the following tests
before calling the Hotline.
Problem Possible Cause Solution
The outlets stop providing
power to equipment. Circuit
breaker button is projecting
from the side of the unit.
Circuit breaker has
tripped due to an
overload.
Turn the UPS off and unplug at least one
piece of equipment. Reset the circuit
breaker by depressing the button, and then
turn the UPS on.
The UPS does not
perform expected
runtime.
Battery not fully charged. Recharge the battery by leaving the UPS
plugged in.
Battery is slightly worn
out.
Contact Hotline.
The UPS will not turn
on.
The on/off switch is
designed to prevent
damage by rapidly
turning it off and on.
Turn the UPS off. Wait 10 seconds and
then turn the UPS on.
The battery is worn out. Contact Hotline.
Mechanical problem Contact Hotline.