Z fold set-up
Refer to Figure 11 on page 19.
1.
Measure the length of the folds required.
2.
Adjust the form stop for each fold plate to the measurement you determined
previously in step 1 as follows:
·
Loosen the locking knobs at each end of the form stop.
·
Using the knobs as handles, slide the stop along the rods until the stop aligns
with the correct settings on the scales. Make sure the scales on each side of
the fold plate show the same settings otherwise the form will not fold squarely.
·
Tighten the two locking knobs.
3.
If the new form is a different width from the last form used, refer to ‘
Adjusting
the form guides
’ on page 22.
4.
Replace the lid.
3. Set-up
Page 18
PS20/30 Iss. 1.
