Multitron - Operating Manual
Operation
Page
92
of
158
20 August 2020
7.4.2
Setting the Parameter Setpoints
To set the parameter setpoints, proceed as follows:
Procedure
1.
Select the desired pair of parameters with the
Select
key (1).
The alphanumeric display field shows the current values of the
selected parameter pair.
2.
To activate programming, tap the
SET
key (2) in the upper or
the lower setting key area, depending on which parameter set-
point should be set.
The alphanumeric display field shows last set setpoint of the pa-
rameter. The
Setpoint
sign indicates, that the parameter setpoint
can be set.
INFORMATION
The
Setpoint
sign lights up for 10 seconds. If you do not make an
entry in that time, you have to tap the
SET
key again.
3.
Use the
Plus
or
Minus
key (3) to set the desired setpoint of the
selected parameter.
After approx. 10 seconds the
Setpoint
sign disappears and the
new setpoint is saved. You can speed up this process by tapping
the
Select
key.
INFORMATION
The entered value is saved automatically. A separate confirmation
is not necessary. If the parameter is already activated, the changes
take effect immediately.
1
2 3
