InFocus PRJ-WALLKIT-13, Руководство по установке

Страница: 2 / 16

PRJ-WALLKIT-13 Installation Instructions
2
Visit the InFocus support site at www.infocus.com/support
DISCLAIMER
InFocus and its affiliated corporations and subsidiaries
(collectively "InFocus"), intend to make this manual accurate
and complete. However, InFocus makes no claim that the
information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in
connection with the installation or use of this product. The
information contained in this document is subject to change
without notice or obligation of any kind. InFocus makes no
representation of warranty, expressed or implied, regarding the
information contained herein. InFocus assumes no
responsibility for accuracy, completeness or sufficiency of the
information contained in this document.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component. The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm) for
wood stud installation, and 1/2" (1.3cm) minimum for steel
stud installation.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the weight of the
projector does not exceed 25 lbs (11.3 kg).
WARNING:
Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING:
Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING:
Do not use this product outdoors.
IMPORTANT ! :
The PRJ-WALLKIT-13 short throw projector
mount is designed to be mounted to:
• an 8" thick bare concrete wall;
• an 8"x8"x16" bare concrete block wall;
• a 2"x4" wood stud (16" on center) wall covered
with drywall of 5/8" maximum thickness; or
• a steel stud (16" on center) wall covered with
drywall of 1/2" minimum thickness.
--SAVE THESE INSTRUCTIONS--