Inflight Fitness CT-CCO, Руководство пользователя

Страница: 14 / 15

CCO ASSEMBLY INSTRUCTIONS
BALLET HANDLES
V. Attach two ballet handles to each Loop Upright using 8 – 4 ¾” bolts, 16 –
washers, 8 – nuts.
SHROUD HOLES AND SHROUD OPTION
W. If no Optional Shroud Kit was purchased install plastic caps in all 24 shroud
holes. If installing Shrouds fasten to Loop Upright using 12 – 3/8 x 2 ½” bolts,
20 – 3/8” flat washers and 8 – 3/8” nuts (hardware found in Shroud box). The
lower two bolts on each side of the Front Shroud fasten into threaded
fasteners pre-installed into the Front Shroud.
ACCESSORIES AND LABELS
X. Attach Weight Labels in recess provided on front of Weight Plates. All the
recesses should be aligned and to the right as you face the weight stack.
Y. Attach the exercise handles to the cable ends using the quick links.
Notes:
At this time check that all the bolts are tight.
At the end of each rear stabilizer there is an
access hole. Use the hex key supplied to adjust
the rubber feet to stabilize the cable cross.
Pin each weight starting from the top plate down
and lift each plate by pulling the exercise
handle(s). This will set the weights in line for
easier pinning.
12