Start/Stop
Forward
Left
Right
Mode
Power ON/OFF
Vacuum Moror ON/OFF
Reverse
Timer
Collided
UV light
Home
18
ON/OFF: After power on main unit (by switch on the Main power switch), you
can press ON/OFF keypad to control QQ6.
START/STOP:Press the Button to begin the automatic cleaning of the room.
Or to stop the activity of the unit, and it will emit a long sound.
Timer: Use this button to set the cleaning time of the QQ6.
UV: Control the UV light turn on or off.
VAC: Control vacuum motor on or off.
COLLIDED: Control cleaner used soft-touched bumper mode or
non-collided.
Home: Use this button to make
6 go back to the charging base.
MODE: Movement pattern selected, press the keypad once to make the unit clean
in :"1" Spot Spiral ( From small spiral to bigger, then bigger spiral to
small, cycling ) "2" Special Bounce, "3" Along wall, "4" S sharp,
"5" Polygonal Spiral, "A" Automatic.
LEFT/RIGHT/REVERSE:Use these buttons to ma ually drive the unit to the
right, left and backward
n
FORWARD: When press Forward, QQ6 go forward and the suction fan is working,
until user release the keypad. If touched obstacle, QQ6 will return.
1.
2.
3.
4.
5.
6
.
7.
8.
9.
10.
Function of each Button:
Remote Control Function
Note:
If the two symbol are all light up (before you s tart setting), please
clear previous ID of Main unit. You can follow the step of instruction e.
c) Let the sonic wall start to study:
If the two symbol are all light up
，
please clear
previous
ID of Main unit
；
If the any one of three symbol is not light up,
please follow below steps.
Step 1: Power on sonic wall the power LED light up ;
Step 2: Use one of toothpick to inset the hole at the back of the sonic wall and
press down, when it emit’’BI’’ sounds
，
one of the three symbol
(must light off before) will light up, it means the sonic wall
complete the study .
Note:
If there are more sonic walls need to study, please operate above steps
again, and at most you can play three sonic walls at the same time.
d) Let the main unit exit study mode:
Push the power button to exit the study mode ,and the main
unit complete the study.
e) Clear previous information of Main unit:
Setting ID with Main unit
Let unit into study model (see step a), press button, all the time ,
until heard “DI-DI” sounds. and all of 4 indicator lamps symbol
are light off, it means cleared previous ID of main unit already, and
you must reset all of ID for charging station, Sonic-wall, Remote
control.
