18
4.8 Menu Programming
Infinova series matrix switching systems provide powerful
menu-driven programming, featuring system tours, salvos, event
timers, access controls and alarm handlings.
Menu programming procedures may vary in several aspects among
different matrix switching systems.
4.9 Macro Setting
4.9.1 Brief Introduction to Macro
Macro is a command sequence, which compiles multiple basic
functions together for operation. User doesn’t have to operate for
each single function.
Macro command can combine a series of basic functions into a
command sequence, such as system tour, salvo, preset and more.
Enter “Macro No. + M2 + RUN” to run the keyboard macro
command. Enter “Macro No. + M1 + RUN” to run matrix macro
command.
4.9.2 Macro Application in V2125 Keyboard
For V2125 keyboard, the Macro is added, modified and deleted via
web page or .txt file. Refer to table below for command.
Macro Command
Type
Type
Name
Parameter
1
Paramete
r 2
Parameter
3
Switch SWITCH
Monitor
No.
Site No.
(Camera
No.)
Camera
No.
Tour
Run RTOUR
Monitor
No.
TURO
No.
N/A
Stop HTOUR
Monitor
No.
N/A N/A
Continue CTOUR
Monitor
No.
N/A N/A
Delete DTOUR
Monitor
No.
N/A N/A
NEXT NEXT
Monitor
No.
N/A N/A
LAST LAST
Monitor
No.
N/A N/A
Arm ARM
Monitor
No.
Arm Type
N/A
Disarm OFF
Monitor
No.
N/A N/A
Call Preset
CPRE
Camera
No.
Preset No.
N/A
Run Pattern
RPATRN
Camera
No.
Pattern
No.
N/A
Auxiliary Switch
AUXON
Camera
No.
Auxiliary
switch No.
N/A
AUXOFF
Camera
No.
Auxiliary
switch No.
N/A
Macro Run
RMACRO Macro
N/A
N/A
No.
Stop HMACRO
Macro
No.
N/A N/A
Table 4-1 Macro Command
Format for Macro programming:
Command: Parameter 1, Parameter 2, Parameter 3
Enter, line feed, tab and space are allowed in front of each
command. Only space and tab are allowed between parameter and
comma. The parameters are identified with a comma in between.
For example:
SWITCH 12, 22, 34
SWITCH 22, 44
Each command is ended with line feed. There's no capitalization
requirement. For SWITCH command, if there are only two
parameters, the second is the camera number, and if there are three
parameters, the third is the camera number.
Besides, the length of the parameter and camera number should be
less than 16 digits, the command name should be no more than 9
characters, the monitor, site, tour, preset, pattern and Macro number
should be less than 3 digits, and the auxiliary switch number and
arming type should be no more than 2 digits.
Macro programming can be added, modified on the web page. User
can also upload txt. files to add and modify. Refer to the section
below for detailed operation.
4.9.3 Macro Programming Method
On V2125 web page, click “Macro Setting” on the tree-shaped
function list. The Macro list will be shown as follows:
User can click the buttons to enter the web page. When user clicks
“Delete”, there’ll be prompt to confirm the operation. User then can
click “Yes” to delete the Macro. When user clicks “Delete All”, all
Macros will be deleted.
Note:
only super users and other preferential users are entitled to
adding and deleting Macros.
The web page for adding Macro is almost the same as that for
deleting Macro. Here we take adding Macro for an example.
The web page is shown as follows:
Add New
Modify
Delete
Delete All
