6
Figure 3-13
Important notes:
1) Super user’s password can only be edited by himself. For the
sake of safety, please change the password as soon as possible.
2) Common user’s password can be edited by both super user and
himself.
3.4 PTZ Settings
Click
button in the navigation bar to display the
PTZ Setting box:
Figure 3-14 PTZ Interface
Camera Address:
set the distributed address of V1700N IP dome.
This address should be in line with that of S1 in DIP switch. The
number of camera address is determined by different control
protocol.
Baud rate:
set the communication baud rate of control and camera
modules, the default value is 9600 bps.
Protocol:
select the corresponding protocol of camera. The built-in
service software in this IP dome supports Pelco P, Pelco D and
Infinova. Infinova is default.
3.5 Network Settings
Click
button in the navigation bar, the following
interface concerning network parameter would display:
Figure 3-15
Unit IP address:
used to set the IP address of V1700 IP dome.
Subnet mask:
used to set subnet mask of V1700 IP dome.
Gateway IP address:
used to set the gateway address of V1700 IP
dome.
When all settings are finished, click “Set” button. The following
interface will appear:
Figure 3-16
Click “OK” button, the system will skip to login interface
automatically.
3.6 Time Zone Settings
Click
button in the navigation bar to display
the following TimeZone Settings interface:
Figure 3-17
Select the desired time zone in the scroll box, and then click “set”
to save it.
There are 26 time zone for selection:
GMT-12:00~GMT~GMT+13:00, among which GMT+08:00 is
Beijing time.
3.7 Software Update
Free software update is provided for V1700N series IP domes, and
this update service can reduce system maintenance budget. You can
download the latest software from the Internet.
Follow the steps below to update software:
1. Click
button in the navigation bar to enter the
Software Update interface shown below:
Figure 3-18
2. Click “Browse” button above, then select program update in the
pop-up dialog box. After that, click “Upload” button, the system
begins to update.
3. If update successfully, the following information will appear on
the current interface:
Figure 3-19
