Infinity 890 HDBF, Инструкция для пользователя, установка и обслуживание

Страница: 10 / 48

P a g e | 9
Issue No 2
890 HD BF USERS INSTRUCTIONS
Cleaning the 890 HD BF Appliance
Ensure the appliance is cold before proceeding.
The outer metalwork frame should be cleaned using a dry duster.
To clean the glass panel , Loosen the bottom 5 M4 nuts but do not remove completely. Remove the
remaining M4 nuts and glass clamps (See Fig 8). Carefully lift the glass panel from within the bottom glass
clamp.
Using a damp cloth and warm soapy water will remove a majority of stains. For more substantial marking we
recommend the use of ceramic hob cleaner. These are available from all leading supermarkets. The brands
of hob cleaner we have tested and found suitable are “Hob brite” & “ Bar Keepers Friend ”. Ensure the glass
is dry and re-assemble.
Note- Never operate the appliance when the glass panel is removed or broken. The glass may discolour quickly when first
installed, and it should be cleaned. This is due to the burning of the refractory fuel bed shapes.
To Clean the Pilot assembly . Loosen the bottom 5 M4 nuts but do not remove completely. Remove the
remaining M4 nuts and glass clamps (See Fig 8). Carefully lift the glass panel from within the bottom glass
clamp. Remove the log and bark chip shapes. Lift out the burner front cover. The pilot is located on the
front right hand side of the appliance, remove any debris in or around the pilot head and the aeration hole.
This can be achieved using the nozzle of a vacuum cleaner. It is advisable not to blow the debris within the
pilot head or aeration hole as this may cause more of a restriction and not rectify the problem.
Note-Take care when cleaning in this area so as not to damage the pilot assembly.
Cleaning the fuel bed shapes. (Please refer to customer protection information on page 2 of this booklet
before cleaning or replacing any refractory materials).
The fuel bed components are delicate and they should be handled with great care. They can be brushed
very gently with a soft brush to remove dust or any deposits. A vacuum cleaner may only be used after the
loose components and moulded shapes have been removed from the 890 HD BF firebox.
It is important that all fuel bed shapes are positioned as shown in these instructions.