Infinity 200300, Руководство пользователя

Страница: 16 / 52

15
Ordercode: 200300
TCYC-7 Cyclorama
Control Panel
A)
B)
C)
D) LC-display
Back/Home button
(hold down >3sec = focus mode)
Menu button
Enter button (PRESS) + Up/down (TURN)
Fig. 13
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Cyclorama will respond to the controller.
Please note when you use the controller, the unit has 21 channels.
When using multiple Cycloramas, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Cyclorama should be 1(001); the DMX address of the second
Cyclorama should be 1+21=22 (022); the DMX address of the third Cyclorama should be 22+21=43 (043),
etc.
Please, be sure that you do not have any overlapping channels in order to control each Cyclorama
correctly. If two or more Cycloramas are addressed similarly, they will work similarly.
Controlling:
After having addressed all Cyclorama fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Cyclorama will automatically detect whether DMX 512 data is received or
not. If not the problem may be:
●
The XLR cable from the controller is not connected with the input of the Cyclorama.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.