Infinite Play Series NVR, Руководство пользователя по установке и эксплуатации

Страница: 13 / 72

INFINITE PLAY
13 EN
3. Basic operation
Note: The button in gray display indicates no support on such devices. .
3.1 Power on:
Plug the power supply and turn on the power supply switch. Power supply indicator light shining
indicates turning on the video recorder. After the start-up a beep sounds. The default setting of video
output is multiple-window output mode. If the startup time is within the video setting time, the timing video
recording function will start up automatically. Then the video indicator light of corresponding channel is
shining and the NVR is working normally.
Note: 1. Make sure that the input voltage corresponds with the switch of the NVR power supply.
2. Power supply source: 220V±10% /50Hz.
Suggest using the UPS to protect the power supply under the unstable electricity conditions.
3.2 Power off:
Press the power supply switch on rear panel to shut down.
1
、
Watchdog after power failure
If the NVR is shut down abnormally, it can automatically backup video and recover previous
working status after power failure.
2
、
Replace the hard disk
Before replacing the hard disk, the power supply switch in the rear panel must be turned off.
3
、
Replace the battery
Before replacing the battery, the setting information must be saved and the power supply switch
in the real panel must be turned off. The NVR uses button battery. The system time must be checked
regularly. If the time is not correct, users must replace the battery.