Infinite Play Flat Z1001, Инструкция по установке и эксплуатации

Страница: 3 / 20

3
EN
FLAT
DESCRIPTION:
Audio-video entrance panel for INFINITEPLAY video door entry
systems.
ENTRANCE PANEL INSTALLATION
ART . Z2001
– Z200D
Installing from flush mounted:
• Install back box Art. Z9092 in vertical position at a height of 165 cm
from the floor to the top edge, as indicated in the figure.
• Secure the pick springs to the back box using the 4 nuts M3, keeping
them aligned plumb with the finish of the exterior wall
• Insert the card names and close the lid on Z2001
• Wire the electronics assembly as shown through the RJ45 connector
• Place the product FLAT within their back box by pressing on the high
and low part of it to facilitate the automatic interlocking.
PLEASE NOTE: The equipment must be directly and permanently
mounted on a non-combustible surface such as concrete and metal.
Supports or materials with poor self-extinguishing requirements must
be excluded.
Removing the FLAT external unit Z2001 - Z200D:
Take the two keys release in the package
1)Insert the key release in the slot (shown in the picture) and press
2)Pull out the product FLAT external unit Z2001 - Z200D
Description connection terminal block:
• Line entrance panel with RJ45 connector
• Interconnecting cables used must be compliant with the CEI 64/8 for
video door entry systems:
- UTP CAT 5e for domestic routes dedicated to video door-phone
system
- FTP CAT 5e shared routes with tension cables
- UTP CAT 5e for outside with protective sheath in PVC
All cables muste be LSZH for Low Smole Zero Halogen
Technical characteristics:
• Brushed stainless steel exterior AISI 316 with ABS frame and glass
parts are made from ultra-strong, scratch-proof.
• Ready to install flush mount wall with metal coupling
•The night light is ensured by 4 efficiency LED
• LCD Display 4.3 " and presence sensor in Art. Z200D
• Standby power consumption 7 mA , in conversation : 150mA
• Operating Temperature : -20 °
to 50
°
C
• Dust and Water Resistant - Rating IP54
•
Size : 310x130x2 mm
Maintenance:
Clean the entrance panel using a soft cloth. Do not use any type of
chemical product.
To remove the Entrance Panel use the appropriate extraction key.
Before re-install the Entrance Panel, close the slot using the
appropriate
stopper, positioning it from the back, as shown in picture below.
Attention: without the stopper the Entrance Panel loses the IP54 class
and could be subject to water and dust ingress!