Table 1
(continued) Kit specification
Clock crystals
12 MHz and 32.768 kHz crystal for CPU
Power
•
Via USB connector (Micro-AB USB) or
•
Via On-Board Debugger (Micro-AB USB)
Connectors
•
EtherCAT
®
Slave IN and OUT interface via RJ45 jack
•
mikroBUS
™
socket (2x8-pin)
•
Arduino compatible connectors (1x10-pin, 2x8-pin, 1x6pin, 2x3pin)
•
USB connector (Micro-AB USB)
•
CAN connector (D-Sub DE-9)
•
EtherCAT
®
Phy-2-Phy connector (not assembled)
•
Serial Wire Debug interface (2x5, 50 mil pitch) to XMC
™
(not assembled)
(on board debugger can be overridden by externally connected debugger)
Debugger
On-Board J-Link debug probe via USB supporting
•
Serial Wire Debug (SWD
•
UART-to-USB bridge (virtual COM)
Others
•
On-board debug probe, based on XMC4200 microcontroller
•
2x EtherCAT
®
Phys
•
CAN transceiver
•
2 user push-buttons,
•
2 user LED
•
Reset push-button
1.1
Key features
The XMC4300 Relax EtherCAT
®
Kit has the following key features and components:
•
XMC4300 microcontroller (ARM
®
Cortex
®
-M4 based), 144 MHz, 256 kB Flash, 128 kB SRAM, LQFP100 package
•
On-board debug probe with USB interface supporting SWD + SWO
•
Virtual COM port via on-board debug probe
•
EtherCAT
®
slave components: 2 EtherCAT
®
phys and 2 RJ45 jacks
•
Prepared for EtherCAT
®
Phy-2-Phy connection for backplane applications (assembly option)
•
Arduino compatible connector and voltage level shifter for 3.3 V / 5 V Arduino shields
•
mikroBUS
™
socket for plug-and-play click boards
™
•
CAN transceiver and CAN connector (D-Sub DE-9)
•
USB interface (Micro-AB USB plug
•
Voltage regulator 5 V -> 3.3
•
2 x User push-buttons
•
2 x User LED
•
Reset push-button
•
12 MHz crystal
•
32.768 kHz RTC crystal
restricted - NDA required!
XMC4300 Relax EtherCAT
®
Kit
For XMC4000 family
1 Introduction
Board User Manual
3
Rev. 1.2
2022-06-20
