Infineon XMC4000 series, Руководство пользователя платы

Страница: 13 / 28

XMC4200 Platform2Go Series-V1
Hardware Description
Board Users Manual 13 Revision 2019-08-30
2.3 Pin Header for Microbus and Shield2Go Connector 1 and 2
The pin header for Microbus and Shield2Go Connector 1 and 2 can be used to extend the evaluation board or to
perform measurements on the XMC4200. Figure 8 shows the available signals at these pin headers. The
Shield2Go pin header is mounted on the bottom . The pin table is also printed onto the top and bottom side of
the PCB in each view.
Shield2Go Connector 1 (bottom) Shield2Go Connector 2(bottom)
1 VDD5
5V
1
VDD5 5V
2 P14.4
AN1 RX P2.14 10
2
P14.9 AN1 RX P2.15 10
3 P14.14 AN2 TX P2.15 11 3 P14.5 AN2 TX P2.14 11
4 P2.5 SDA RST/GPIO2 P0.8 12 4 P2.5 SDA RST/GPIO2 P0.6 12
5 P3.0 SCL GPIO1 P0.4 13 5 P3.0 SCL GPIO1 P2.1 13
6 GND GND CS P0.2* 14 6 GND GND CS P0.9* 14
7 VDD3.3 3V3 SCLK P1.8* 15 7 VDD3.3 3V3 SLCK P1.8* 15
8 P0.5 INT/GPIO3 MOSI P1.9* 16 8 P0.3 INT/GPIO3 MOSI P1.9* 16
9 P1.2
PWM/GIO4 MISO P0.0*
17 9
P1.3 PWM/GPIO4 MISO P0.0*
17
(Bottom View) (Bottom View)
Microbus Connector
1 P14.8
AN PWM P1.1 16
*Note:

The SPI channels MOSI MISO and SLCK
are connected with both shields and the
microbus.

Each of the three mentioned connectors
has an own CS (Chipselect) channel.
2 P2.7
RST INT P0.10 15
3
P0.7* CS RX P2.15 14
4
P1.8* SCK TX P2.14 13
5
P0.0* MISO SCL P3.0 12
6
P1.9* MOSI SDA P2.5 11
7 VDD3.3
3.3V 5V VDD5 10
8 GND
GND GND GND
9
(Top View)
Figure 8 Signal mapping of the pin headers for Microbus and Shield2Go Connector 1 and 2