User Manual
14
<Revision 1.2>
<2018-06-27>
EVAL-M1-183M User Manual
iMOTION
™
Modular Application Design Kit
Getting Started with EVAL-M1-183M
5.2.2
MCEWizard setup overview
After installing the 100 Series Installer, the shortcut for MCEWizard appears on the Windows desktop. Double
click the shortcut to open the MCEWizard and configure the parameters for evaluation boards or motor. Figure
8 shows the “Welcome Page” for MCEWizard, where the Reference Design board IRMCS1183-1-D should be
selected through the pull-down list for the MADK control board EVAL-M1-183M and the matching power board.
Infineon keeps releasing new MADK controller and power boards. Therefore, it could happen that some of the
newest power boards are not pre-configured in the MCEWizard tool and cannot be selected through the pull-
down menu. In that case, the user should select any other power board (as similar as possible) and follow the
MCEWizard setup steps by entering the parameter values which are specific to the chosen board. Make sure
both “I have modified the circuit board” and “Enable advanced question” checkmarks are selected. Please refer
to the Application Note of the corresponding power board for additional information.
After selecting the MADK control and the power board, start the MCEWizard system setup procedure by clicking
the “Next” button in the right bottom corner as shown in Figure 8.
Figure 8
Welcome Page of MCEWizard
iMOTION
™
MADK system enables users to easily test different combination of control and power board with
their motors. User should be familiar with the system level parameters which are related to the motor used.
There is a very limited number of parameters which are specific to the control board or power board hardware.
Table 6 provides the MCEWizard setup overview for hardware related parameters. Similar tables will be
available in each power board’s Application Note. Combination of this table and the corresponding table of the
power board provides enough information to setup the MADK-based motor drive system in shortest time.
Table 6
MCEWizard setup overview table
Page
Parameter
Value
Comment
Welcome Page Reference Design selecting
IRMCS1183-1-D
For EVAL-M1-183M only
Options Page Motor 1 Shunt Configuration
Refer to the power board user
manual
Leg Shunt for power
board EVAL-M1-05-
65D