User Manual
10
<Revision 1.2>
<2018-06-27>
EVAL-M1-183M User Manual
iMOTION
™
Modular Application Design Kit
Getting Started with EVAL-M1-183M
5
Getting Started with EVAL-M1-183M
In order to run the motor system, a combination of the iMOTION
™
MADK control board EVAL-M1-183M and the
matching MADK power board (with M1 connector, EVAL-M1-05-65D for example in this chapter) is required. The
100 Series Installer for iMOTION
™
PC Tools (MCEProgrammer, MCEWizard and MCEDesigner) are also required
in order to initially setup the system, as well as to control and fine-tune the system performance to match users
exact needs. This chapter provides more details on setting up the system and getting started with iMOTION
™
MADK development platform.
5.1
Setting up the system
After downloading and installing the 100 Series Installer for iMOTION
™
PC Tools (MCEProgrammer, MCEWizard
and MCEDesigner, and the 100 Series Installer can be downloaded on the iMOTION
™
Software web page
www.infineon.com/imotion-software
), following steps need to be executed in order to run the motor. Refer to
the chapters 5.2.1, 5.2.2 and 5.2.3 as well as MCEProgrammer, MCEWizard and MCEDesigner documentation for
more information.
Figure 4
System connection example using EVAL-M1-183M and EVAL-M1-05-65D
1. Connect USB-JTAG connector on the MCETOOLV2 to the PC via USB cable.
2. Connect JTAG connector on the MCETOOLV2 to the JTAG Connecter J1 on the control board EVAL-M1-183M
via JTAG cable.
3. Turn on the Power Switch button on the MCETOOLV2, and then open the installed PC tool MCEProgrammer
to program firmware to the flash of iMOTION
™
IC IRMCF183. Refer to Chapter 5.2.1 or MCEProgrammer User
Guide for more details.
UART-USB
Connector
Motor Phase
Outputs
AC Power
Input