Infanor SMT-BD1/m, Руководство пользователя

Страница: 41 / 58

41
SMT-BD1/m
Appendix
Chapter 8 - Appendix
1 - USING SMT-BD1/m WITH A DISPLAY TERMINAL
1.1 - CONFIGURATION
1.1.1 - TERMINAL CONFIGURATION
- A display with 4 lines of 20 characters each:
- A keyboard with:
0..9 keys,
ENTER key,
arrow keys.
- A serial link RS232:
19200 baud, 1 stop bit, no parity,
Protocol VT-100.
1.1.2 - POSITIONER CONFIGURATION
SMT-BD1/m with EPROM version 5.98 or higher.
Switch SW2.4 = OFF
PC mode: this mode is used to communicate with the PC software VDSetup, version
1.07 and higher.
Switch SW2.4 = ON Terminal mode to communicate with a VT-100 terminal.
The switch SW2 is next to the X4 connector.
It is also possible to switch between these modes by means of the push button (Offset) on the front panel.
1.2 - USE
1.2.1 - MAIN MENU
In the main menu, it is possible, with keys 1, 2, 3 or 4:
1 - to display the motor position and the user can move the motor (Jog+ or Jog-) by means of the arrow keys.
2 - to modify a defined sequence:
modification of the position of a defined sequence: the operator enters the sequence number and its new
programmed position.
modification of the speed of a defined sequence: the operator enters the sequence number and its new
programmed speed.
3 - to run a sequence: the operator enters the sequence number to execute.
4 - to move to a position: the operator enters the position to move to.
1 Display position
2 Modify sequence
3 Run sequence
4 Move_