Inepro MagStripe - PayCon II, Инструкция по эксплуатации

Страница: 4 / 7

2 - MagStripe - PayCon II Assembly
Magstripe Assembly
Magstripe Assembly
Attention!!
Read this manual carefully before installing this device!
Main connection
Before connecting the device to the mains, check if the mains supply voltage corresponds to the voltage printed on the
type plate of the adapter. If the mains voltage is different, consult your supplier.
Guarantee
No guarantee can be given if safety regulations are not followed.
Security
Always disconnect the power supply before handling anything inside the device.
Installation
This device has to be installed by authorised personal only.
2 Screws Card reader unit Spacer
The Magnetic card reader is used to provide communication between the PayCon and a Magnetic card.
Read this instruction to learn how to attach a Magnetic Card Reader to the bottom of a PayCon or PayCon bracket.
When you receive our Magnetic Card Reader Kit, please check if you have received the parts shown in the image above.
Parts list
·
Card reader unit
·
Plastic spacer (bracket use only)
·
2 Screws
Optional Parts
·
PayCon bracket kit (bracket use only)
Tools required
·
Phillips number 2 screwdriver
Use the following steps:
1. Turn over the PayCon or PayCon bracket
2. Align the card reader unit with the screw holes. Make sure you align it to the proper side, which side is the proper side
will differ when the PayCon is attached to, for instance, a copier or to a wall
3. Guide the Magstripe data, the PayCon power and network cable and any other cables (copier) the PayCon has to be
connected to, trough the bracket hole(s)
Magstripe COM 1
connection
closed flap w ith
pow er cable and
Magstripe connected
PayCon w ith all flaps
closed