3.
Obstacle detection.
Before setting end positions the motor detects only low rotation from overload. Obstacle detection function is
active after setting both end positions.
For downwards movement the motor will stop and go up for a distance of about 25 % of shutter length.
In case of blockade the roller shutter in upwards direction after detecting lowering of rotation the motor will
stop and go downwards to release tension.
While starting movement from upper end position obstacle detection system will work with a delay of
half/one/one and a half spin of a motor. This parameter can be change by simultaneously pressing the '▲'
and '▼' buttons and then the ▲ to increase or ▼ to decrease. The motor will make from 1 to 3 moves
depending on the value, one=half, three= one and a half. (After setting end positions).
Obstacle detection function is active to place where the motor automatically stopped during setting bottom
end position (point B.e). Below that point obstacle detection function is not active.
4.
Troubleshooting.
Problem
Couse
Solution
Motor do not react to
commands
Thermal protection worked
Wait from 10 to 20 minutes
Too quick change of directions
Wait about 5 seconds between releasing and
pushing button
Gaps between slats
Clearance between winding pipe and
driver
Connect winding pipe and driver with screws
Lockups of armour in guides
Check guides of shutter and slats
Self-stopping of
motor
Lockups of armour in guides
Check guides of shutter and slats
Motor do not detect
obstacles
End positions set in wrong order
Return to initial settings and set end positions
Moving of end
positions
Sliding of crown in winding pipe
Match winding pipe to crown
Mechanical malfunction
Change motor
P.I.E. INEL Sp. z o.o.
ul. Mostowa 1
80-
778 Gdańsk
March 2016
