1.
Setting the end positions of the drive
PROGRAM THE TOP END POSITION FIRST, THEN THE BOTTOM END POSITION.
Upon installation, the drive performs a short up and down motion, which signals lack of end
positions.
While programming the end stop values, the engine will start, then stop for a moment, then continue its motion.
There are two methods of programming end positions:
A.
Manual
a.
Check if the directions of the roller blind movement correspond to the directions indicated on
the manual switch. Place the roller blind in the middle position.
b.
Tense the roller armour by pulling the bottom slat down.
c.
Simultaneously press and hold the '▲' and '▼' buttons until the motor makes short move
up – down. (Start of setting end positions).
d.
Press and hold the '▲' button. The roller blind will move upwards. Stop it before the desirable
top end position by releasing '▲' button. Using '▲' and '▼' buttons set end position.
e.
Simultaneously press and hold the '▲' and '▼' buttons for about 5 seconds, the motor will
makes short move down – up. (Confirming the top end positions)
f.
Press the '▼' button, the roller blind will move downwards. Motor will automatically stop on the
windowsill.
•
Position can be changed by pressing '▼' button again. Repeat for desirable shutter
position.
g.
Confirm the bottom end position by simultaneously pressing and holding the '▲' and '▼'
buttons for about 5 seconds, the motor will makes short move up – down.
h.
Press the '▲' button. The motor will move upwards and stop at the top end position.
i.
Motor will perform a short up and down movement. With this the programming is finished
.
B.
Automatic (requires stoppers)
a.
Check if the directions of the roller blind movement corresponds to the directions indicated
on the manual switch. Place the roller blind in the middle position.
b.
Tense the roller armour by pulling the bottom slat down.
c.
Simultaneously press and hold the '▲' and '▼' buttons until the motor makes short move
up – down. (Start of setting end positions).
d.
Press and hold the '▲' button. The roller blind will move upwards and stop at the upper
stopper. If it stops earlier, press the '▲' button once again.
e.
Press the '▼' button. Motor will perform a short down – up movement. The motor will
register the new top end position and move downwards, it automatically stops on the
windowsill.
•
Position can be changed by pressing '▼' button again. Repeat for desirable shutter
position.
f.
Press the '▲' button. Motor will perform a short up – down movement. The motor will
register the bottom end position, move upwards, and stop at the top end position.
g.
Motor will perform a short down – up movement. With this the programming is finished.
2.
Return to initial settings (end positions deletion)
Simultaneously press the '▲' and '▼' buttons for about 10 seconds, motor will perform two short
up – down movements. The drive will return to the initial settings. Following this procedure you will need
to re-program the end positions.
