Remote control registration
Controlling from remote control is possible after registering one of his channels to the drive or controller.
There are three ways of getting into the programming mode in our receivers:
•
First programing after every connection to power supply(radio drive, ST-01RL).
•
Programming ST-01R controller.
•
Programing with a previously registered remote control.
First programming in case of radio drives and ST-01RL controller:
•
Select on RCU channel number desired to be registered,
•
Connect to the drive or controller AC power supply,
•
push the buttons "
▲
" and "
▼
" simultaneously on the RCU,
•
the drive will move up and down,
•
in the next 10 seconds press shortly the button "
▲
",
•
a short move up and down will confirm the registration right.
CAUTION: This procedure will cause the drive memory to erase all the channels that were previously
registered.
Programming ST-01R controller:
•
Press programming switch S1 on the ST-01R controller,
•
press shortly the button "
▲
",
•
controller will confirm the registration with diode blinking green and red.
When a registered remote control is at disposal, other channels of the same or other remote
control must be registered without cutting off the power.
The programming mode must be initiated on a drive with the use of a registered remote control.
•
press shortly the buttons "
▲
" and "
▼
" simultaneously on a registered remote control,
•
the roller blind will move up and down, next it will make a short series of moves up and down equal to the
number of registered channels,
•
during the next 10 seconds the drive will remain in the programming mode,
•
in these 10 seconds the button "
▲
" must be pressed shortly on a new remote control.
With this method any channel can be registered to any drive, but only in case there is an already registered remote
control.
Change of the movement direction of the roller blind.
If it is necessary to change the direction of movement of the roller blind (the movement is opposite to the directions on
the remote control), the drive must be set in the programming mode (using a registered remote control) and next the
stop button
▀
needs to be pushed.
Replacing the batteries
The remote control is powered by two 1,5 V batteries type AAA and one 12 V battery type A23. To replace the
batteries, remove the four screws on the back and lift the back lid.
P. I. E. INEL Sp. z o. o.
ul. Mostowa 1
www.inel.gda.pl
80-778 Gda
ń
sk
POLAND
