28
28
Controller Firmware Update
The NPC
‐
2006 controller can be updated using the USB interface. An update installs new
fi
rmware (so ware) into the controller.
The
fi
rmware update
fi
le should be copied to C:\My Documents\Nitrous Power Controller\Firmware Updates so it can be located easily
during the update process.
When the controller enters update mode a copy of the current installed
fi
rmware will be made and placed into the update
fi
le directo
‐
ry automa cally. If an iden cal
fi
rmware
fi
le already exists no second backup copy will be made.
Important—do not turn o
ff
power to the controller or unplug the USB cable during the update process. If this does occur the controller
will remain in update mode and when the USB connec on is established again the update process must be completed from the begin
‐
ning.
Important—make sure the nitrous arming switch is o
ff
during the
fi
rmware update process.
1—turn power on to the controller and connect the USB cable. Launch the PC so ware.
2—Click on “Update Controller Firmware” from the Controller menu.
3—click on Yes to con nue and put the controller into update mode.
4—once the controller reboots in update mode click on the “Close” bu on to con nue the
fi
rmware update process.
Con nued on next page.
