8
GB
Using
t
h
e
h
ob
Lig
h
ting
t
h
e
burners
For each BURNER knob there is a complete ring
showing the strength of the flame for the relevant
burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting
-
.
3. Adjust the intensity of the flame to the desired
level by turning the BURNER knob in an
anticlockwise direction. This may be the minimum
setting
+
, the maximum setting
-
or any position in
between the two.
If the appliance is fitted with an electronic lighting
device* (
see figure
), press the ignition button,
marked with the symbol
, then hold the BURNER
knob down and turn it in an anticlockwise direction,
towards the maximum flame setting, until the burner
is lit. The burner may be extinguished when the
knob is released. If this occurs, repeat the operation,
holding the knob down for a longer period of time.
If the flame is accidentally extinguished, switch off
the burner and wait for at least 1 minute before
attempting to relight it.
If the appliance is equipped with a flame failure
safety device*, press and hold the BURNER knob for
approximately 3-7 seconds to keep the flame alight
and to activate the device.*
To switch the burner off, turn the knob until it reaches
the stop position .
P
ractical
ad
v
ice
on
using
t
h
e
b
urners
For the burners to work in the most efficient way
possible and to save on the amount of gas
S
tart
-
up
a
n
d
us
e
consumed, it is recommended that only pans that
have a lid and a flat base are used. They should
also be suited to the size of the burner.
To identify the type of burner, please refer to the
diagrams contained in the Burner and nozzle
specifications.
U
sin
g
the o
v
en
The first time you use your appliance, heat the
empty oven with its door closed at its maximum
temperature for at least half an hour. Ensure that the
room is well ventilated before switching the oven off
and opening the oven door. The appliance may emit
a slightly unpleasant odour caused by protective
substances used during the manufacturing process
burning away.
Before operating the product, remove all plastic film
from the sides of the appliance.
1. Select the desired cooking mode by turning the
SELECTOR knob.
2. Select the recommended temperature for the
cooking mode or the desired temperature by turning
the THERMOSTAT knob.
A list detailing cooking modes and suggested
cooking temperatures can be found in the relevant
table (
see Oven cooking advice table
).
During cooking it is always possible to:
Change the cooking mode by turning the
SELECTOR knob.
Change the temperature by turning the
THERMOSTAT knob.
Set the total cooking time and the cooking end
time (
see below
).
Stop cooking by turning the SELECTOR knob to
the 0 position.
Never put objects directly on the bottom of the
oven; this will avoid the enamel coating being
damaged. Only use position 1 in the oven when
cooking with the rotisserie spit.
Always place cookware on the rack(s) provided.
*
Only available in certain models.
Burner
ø Cookware diameter (cm)
Fast (R)
24 - 26
Semi Fast (S)
16 - 20
Auxiliary (A)
10 - 14
HOB GAS BURNER
SAFETY DEVICE
ELECTRONIC
LIGHTING DEVICE
