Indesit HI561 IXUK, Инструкция пользователя

Страница: 6 / 12

6
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
GB
Note: ensure that the wall bracket (I) is levelled. The hood can be aligned or adjusted
in height by rotating the adjustment screws (see below).
• Mark on the wall the centres of the two keyholes of the bracket.
Fixing the wall brackets item 2:
• Place one of the two brackets (item 2 fig. 1 ) 15 mm from the ceiling or from a horizontal
line drawn between the top of the adjoining wall cabinets, ensuring that the bracket is
level and mark the centres for the keyhole bracket fixing screws.
• Place the other wall bracket (item 2 fig. 1 ) on the wall at “X” distance. This measurement
should be determined by the height of the upper chimney stack and mark the centres for
the keyhole bracket fixing screws.
• Pilot drill all the hole positions as marked on the wall using an 8 mm drill and fix the wall
brackets 1 - 2 using the rawl plugs and screws supplied.
Splashback (optional)
When a splashback is to be fitted, the distance between the cooker hood and the cooking
appliances will be determined by the height of the splashback, item
B . The splashback is
to be installed before installing the canopy. If the splashback is to be fixed to the wall
using both the top and bottom fixing holes care must be taken to ensure that the
splashback is fitted at the correct height before fixing it into position. The fitting should
be undertaken by a a competent person with experience in this type of installation. If the
splashback is to be fixed through
only the top fixing holes proceeds as follows:
• Put the splashback on the worktop as illustrated in fig. 2a ; then holding it against the wall
to ensure that it is correctly positioned mark the holes for the top fixing screws on the
wall.
• Pilot drill the wall using an 8 mm drill and fix the splashback using the 8 mm rawl plugs
and screws supplied.
• If the fixing holes in the bottom of the splashback are not to be used to secure the
splashback to the wall the installer should ensure that the bottom edge is tucked down
behind the rear of the worktop.
Fixing the canopy hood
• Adjust the two screws V (on the canopy
connection points) to approximately
half way.
• Hook the rear of the canopy to the wall
bracket 1 , after anchoring the latter to
the wall.
• Turn the screws V to adjust the canopy
vertically and level it horizontally .
• Fit and lock the central fixing screw V1
(provided) to lock the canopy in place
(
fig.3 ).
Fig. 3