10
GB
How to carry out a
drying cycle
Starting and selecting a programme
1.
Plug the dryer into the power supply socket.
2.
Select the programme according to the type of laundry
(see Laundry).
3.
Open the door, ensure that the filter is clean and securely placed and that the water container is empty and correctly slotted
(see
Maintenance).
4.
Load the machine, making sure that no piece of laundry gets between the door and the relative seal. Close the door.
5.
Press the ON/OFF button to switch on the machine.
6.
After consulting the programme chart and the indications for each type of fabric (
see Laundry
), turn the Programme selection
knob towards the programme corresponding to the type of laundry to be dried
(see Programmes and options).
!
Warning: If the position of the programme selection knob changes after pressing the START/PAUSE button, the selected
programme will NOT be modified. To modify the programme, press the START/PAUSE button to put the programme in pause mode
(the indicator light flashes orange), then select a new programme and the relative options. Press the START/PAUSE button to start
the new programme.
7.
Select the ”Timed Drying” function by pressing the timed drying button until the required time is dispayed
(see Programmes and
options).
8.
If necessary, set the time of the delayed start and any other options
(see Programmes and options).
9.
Press the ALARM
button to sound a buzzer signalling the end of the programme.
10.
Press the START/PAUSE button to start the drying cycle. The display will show the approximate time remaining.
Laundry can be checked while the drying programme runs and any garments already dry can be removed, while drying continues
for the remaining items. After closing the door, press the START/PAUSE button to resume machine operation.
11.
The final COOL TUMBLE phase (i.e. the fabrics are cooled) activates during the last few minutes of the drying programme;
always allow this phase to terminate.
12.
At the end of the drying cycle the display shows END.
The buzzer will beep 3 times to let you know that your programme is complete. (Note: If the SOUND option was selected the buzzer
beeps 3 times every 30 seconds for 5 minutes).
Open the door, remove the laundry then clean the filter and replace it. Empty the water container and put it back in its slot
(see
Maintenance).
If the clothes are not removed at the end of the cycle the automatic
Anti Craese
action will, on those programmes with this feature,
continue to rotate the drum intermittently for up to 10 hours to minimise creasing. Opening the door or pressing the OFF button will
stop the
Anti Crease
action.
13.
Disconnect the dryer from the power supply.
Automatic pre-post Anti Crease
This is an automatic function which provides an anti crease treatment both before and after the drying programme. By periodically
rotating the drum before the start of the drying cycle, when a delayed start is selected, the formation of creases is prevented. On
certain programmes the drum also rotates periodically at the end of the drying cycle on. This post crease care action continues until
either the door is opened or the
OFF
button is pressed.
Standby mode
This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled
after about 30 minutes if no activity is detected. Press and hold the
ON/OFF
button until the dryer reactivates.
