inDESIGN iD-HP Series, Руководство по установке и эксплуатации

Страница: 5 / 12

iD-HP SERIES SUBWOOFERS: INSTALLATION & OPERATION MANUAL PAGE 5
CONNECTIONS
Located on the rear panel of each loudspeaker you’ll find 2x NL4 speakon connection points. Use either of
the two connection points to connect the loudspeaker to an amplifier.
Note: You may use the second NL4 connection to link to another loudspeaker. Take note of your
impedance load as to not overload the connected amplifier.
Speakon Wiring
The loudspeaker connectors are wired pin 1+ and pin 1-
2 + Not used
2 - Not used
Speaker Cable
The gauge of speaker cable should be the heaviest gauge where practical to reduce transmission power
loss from the connected amplifier.
4.00 mm2 cable is a popular gauge for low extension products. A gauge smaller than 2.5 mm2 should be
avoided when wiring the iD-HP15SUB and iD-HP18SUB products.
SPEAKER MOUNTING
The iD-HP15SUB and iD-HP18SUB are a ground-based
design.
They were not designed to be flown at height.
Cabinet Stacking
Users may stack multiple sub enclosures together.
Note: Users must ensure the cabinets are strapped
and/or secured correctly to prevent the stack from
toppling over.
Top Hat Mounting
Each sub model comes equipped with a 35mm top
hat mount installed into the top of the cabinet. Use
a sub-satellite mounting pole to couple a mid/hi box
with your sub.