Qty.
NO. DESCRIPTION.
1.
2A.
2A.
2B.
2C.
3.
4.
5.
6.
7.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
22.
23.
24.
26.
27.
28.
29.
33.
1
1
1
4
1
1
1
2
1
6
2
1
2
1
1
1
1
1
1
1
4
1
1
1
1
1
1
1
1
CYLINDER
WATER TANK
STAND
BOLT
SUPPORT
PLUNGER
HANDLE
SUPPORT PIN
CENTER PIN
SNAP RING
PLUNGER O-RING P-22
SUCTION CASE
SUCTION & DELIVERY VALVE
SPRING
SUCTION O-RING P-14
STRAINER
VALVE JOINT
DELIVERY O-RING P-15
AIR GAUGESTAND
SPINDLE
BOLT
GREASE CAP
PRESSURE GAUGE
PRESSURE HOSE
GRIP
SUCTION VALVE
O-RING P-18
BUSHING
NAME PLATE
Page # 2- M:231C
PRESSURE TESTING PUMP
CONSTRUCTION
PRESSURE TESTING PUMP
FEATURES :
The Testing Pump is very compact, light in weight and can be unbolted to carry easily.
Stand is designed in such a way to keep on plane surface and operate without any foundation. Even
in Testing Pumps also no fixing or foundation is needed. All the working parts are made of stainless
steel & Fiber. All the joints are threaded so that any part can be easily replaced even at site also.
Page # 1- M:231C
2
Prod.
No.
231C
Strock
Capacity of
Water Tank
Weight
Accessories
Memo
Plastic
Tank
35mm
13c.c.
5L
5 Kgs. Pressure Hose 1
Bushing 1/2x1/4 1.
Rate of Water Section
Per Stroke
Maximum
Pressure
6MPa
60kg/cm
Unit Conversion :
1MPa = 10Bar = 10.1972kg/Cm²/ = 145.038Psi
1. Install the stop valves to the test pipe (#1,#2).
2. Fill up the test pipe with water by the use of service water or other
supply source.
3. When the test pipe is filled with water, remove air and close the valve
(#2).
4. Connect the tester and the test pipe with the attached pressure-resistant
hose ass'y.
5. Fill the water tank of the tester with water and operate the pump.
6. Open the stop valve (#1) of the test pipe and continue the operation to
fill up with water.
7. When the pressure gauge No.23 equipped to the tester rises to the
required pressure, stop operate the pump.
8. If the pressure does not drop, the test pipe is perfect.
9. If the pressure drops, it is indicative of leakage caused somewhere on
the test pipe.
TESTING PROCEDURES
