Indel Webasto isotherm 101N0212, Инструкция по эксплуатации

Страница: 42 / 212

ISOTHERM Digital Display
42
the compressor is enabled to operate at maximum revolutions
(3500 rpm) if voltage conditions permit doing so. See the
paragraph on battery protection level.
• «3» Segment display, indicates the instantaneous temperature
in the area in which the temperature sensor has been installed.
If buttons «6» or «7»are pressed, flashes to indicate the set
temperature and any new temperature set if buttons «6» or «7»
are pressed again. To store temperature, wait approximately 8 sec.
At that point, the display will go back to showing the temperature
taken by means of the temperature sensor. Otherwise, you can
more quickly store the new temperature by pressing button «2» .
• «4» Indicates when you are in ITC mode (standard).
• «5» Indicates when Eco mode is active.
• «6» increases the number or data when the display is in data
setting mode.
• «7» decreases the number or data when the display is in data
setting mode.
- Equipped with an advanced function menu where you can:
o Select 3 possible battery protection values
o Define temperature offset for 3 operating temperature ranges
o Set degrees in Centigrade or Fahrenheit
o Select permanent Over Cooling function, when the system has excess
voltage/power available proportionate to the level of battery saving
selected
o Define the minimum temperature setting limit
- Sub-menu Configuration functions:
To enter into display set-up functions (settings):
o Switch off the system if on.
o Simultaneously hold and press the buttons: «2» , «6» , and «7» for
approximately 6 sec.
o Once you have entered into the configuration menu, parameters are
arranged in a drop-down menu and you can scroll through them using
buttons «6» , «7» and you can modify a desired parameter by pressing
button «2» . Again use buttons «6» , «7» to change the parameter