Indel B sleeping well arctic plus SW2000PLUS, Инструкция по установке, обслуживанию и эксплуатации

Страница: 20 / 26

20
SYSTEM MAINTENANCE
Condenser Compressor Box Evaporator Batteries (Accessory)
Spring Visual Inspection Visual Inspection Visual Inspection Visual Inspection
Summer
Fall Visual Inspection Visual Inspection Visual Inspection Visual Inspection
Winter
Condenser - Visual Inspection - Core should be clear/free of dirt and debris.
-
Bracket mounting bolts are tight and secure to rear exterior sleeper wall.
- Freon High/Low connections are not damaged and are secure.
- Electrical connection is not damaged and is secure.
- WARNING! Never use high pressure washing system on condenser.
Compressor Box - Visual Inspection - Hold down bolts are tight and secure to floor.
- Freon High/Low connections are not damaged and are secure.
- Electrical connections are not damaged and are secure.
- Cooling Duct is connected, not damaged.
Evaporator - Visual Inspection - Mounting bolts are tight and secure.
- Freon High/Low connections are not damaged and are secure.
- Electrical connections are not damaged and are secure.
Batteries - Visual Inspection - Mounting bracket/hold down is secure.
- Terminal connectors are clear of corrosion and secure.
SYSTEM TEST
If any concerns are found during the Visual Inspection, please refer to the Installation Guide for
service recommendations. Once the above System Maintenance has been completed and any
concerns are corrected, start and operate the SW system for 30 minutes. Verify the Condenser,
Compressor Box and Evaporator fans are operating. Check the evaporator output to ensure system
is producing cold air!
GENERAL OPERATION
When operating the air conditioning system, the windows and doors of the vehicle should be closed
for best sleeper cooling. Pre-cooling the cab will extend run time and battery life.
When the system is not in use for long periods of time, the SW system should be run and operated
for 30 minutes during standard truck in-shop maintenance. This will lubricate moving components
and prevent them from drying out due to long periods of inactivity.
SW2000Plus Instructions
Rev D – October 29, 2012