Indel B sleeping well arctic plus SW2000PLUS, Инструкция по установке, обслуживанию и эксплуатации

Страница: 18 / 26

18
ERRORS SHOWN ON THE DISPLAY (AC / FAN)
Description Message Symbol
Battery Voltage
(The battery-saver device has cut out. Voltage has fallen below the value of 10.8V D.C.)
E1
Fan Over Current Cut-Out
(The condenser or evaporator fan overloads the central control unit above the limit
allowed. Possible cause: short circuit or blockage of fan rotation.)
E2
Compressor Locked
(The rotor is locked or the pressure inside the cooling circuit is too high.)
E3
Minimum Compressor Rotation Speed
(If the cooling circuit is overloaded, the compressor cannot maintain the minimum rotation
speed.)
E4
High Temperature on the Central Control Unit
(If the cooling circuit is overloaded or the ambient temperature is high, the central control
unit signals this situation.)
E5
Communication Error
(There is no communication between the display and the central control unit.)
E6
Temperature Sensor
(Temperature sensor is in short circuit or the wiring of the sensor are not connected and
thermostat switched off the system. System is without gas and pressure valve open the
electric contact switching off the system.)
E7
TEMPERATURE UNIT
When the system is switched off, it is possible to change the temperature unit, choosing between
°C (Celsius) or °F (Fahrenheit) .
Press
VENT + , VENT - , TEMP + and TEMP - , buttons simultaneously to show the present unit (°C)
on the display, and the temperature symbol will light up (see fig.4) .
Quickly press
VENT + or VENT – to select the unit required.
REMOTE CONTROL
The remote control regulates both the conditioning function and the fan function.
Using the remote control it is possible to:
- Switch the system on and off
- Regulate the temperature
- Regulate the fan speed
- Engage the OPTION function