INDA A0452DWW, Руководство пользователя

Страница: 5 / 28

5
●
Do not use hair-spray while the appliance is switched on.
INSTALLATION:
Attention: before installing the wall holder always switch off the general
switch of your mains electricity.
Each time the appliance is opened, the switch must be used to disconnect
the appliance.
The cable to connect to the power supply must be type H05VV-F 2x1,5
mm².
1
Fasten the appliance inside the drawer with three D screws (not provided).
Drill a hole into the drawer and place an insulating rubber cable duct E to
insert the power cable. (fig.1)
2
Fasten the terminal board to a fixed and not accessible part, even after
removing the drawer, using 4 screws H (not provided). Do not fasten the
terminal board to the drawer. (fig.2)
3
Open the terminal board L with the help of a screwdriver. (fig.3)
Loosen the cable clamps M and N . (fig.3)
Insert the cable of the hair-dryer into the cable clamp O and connect the
wires to the terminal board.
Fasten the cable clamp M making sure the sheathing is kept inside the
terminal board. (fig.3)
Insert the mains wiring into the cable clamp P and connect the wires to the
terminal board.
Fasten the cable clamp N making sure the sheathing is kept inside the
terminal board. (fig.3)
Close the terminal board. (fig.3)
Make sure the mains wiring is not in contact with any sharp edges, the
opening and closing of the drawer should not cause any crushing of or
damage to the wires.
USE and PRODUCT CARE:
Pushbutton B (Fig.0):
ON
= On/Off (pressure must be maintained to operate the hairdryer)
Slide Switch C (Fig.0):
Cool
= (low power)
1 = (medium power)
2
= (maximum power)
●
When not in use, the mains switch on the wall holder
A
(Fig.0) should be
in the “Off” position.
●
The hairdryer requires no special care or attention.
●
You can clean your appliance with a cloth dampened with water.