Micro adjusting:
Fine-tuning the position of your Shop Stop relative to a
cutter is easy and accurate. Just loosen the two black
thumbscrews on top of the Shop Stop body about
1
⁄
8
turn,
then turn the machine screw located at the end of the Shop
Stop (Fig. 5). Each full turn of the screw moves the stop
exactly
1
⁄
32
". Turning the screw clockwise moves the stop
surface closer to the cutter. To move the stop surface away
from the cutter, turn the screw counterclockwise as you
push the stop body toward the screw. Always tighten the
two black thumbscrews after micro adjusting.
Converting from standard to expanded
clamping mode:
Your INCRA Shop Stop comes assembled in the standard
clamping mode. This setup will clamp to virtually any of the
INCRA Fences including the ULTRA, ULTRA LITE, TWIN
LINEAR and Original INCRA JIG Fences plus the New INCRA
Miter Sled and the INCRA Track. In the standard mode you
can even clamp the Shop Stop directly to any piece of
3
⁄
4
"
plywood or hardwood. Youʼll find this feature perfect for those
occasions when you want to extend the length or height of
your INCRA fence with a
3
⁄
4
" subfence. A second “expanded”
clamping mode allows the use of your Shop Stop after attaching
a wooden auxiliary fence to your INCRA Fence. (Fig 6).
Adding a wooden auxiliary fence to your INCRA Miter Sled,
chop saw, or INCRA JIG Fence can be very beneficial in that it
provides zero clearance between the cutter and the fence. A
zero clearance auxiliary fence often translates to safer and
cleaner cuts since the smaller opening provides more support
for the workpiece at the cut.
The two piece design of the INCRA Shop Stop permits use of
a
3
⁄
4
" thick wooden auxiliary fence without interfering with the
stop's ability to clamp to your INCRA Fence. To change the
stop to expanded mode, loosen the two black thumbscrews
and slide the stop body (red) off of the stop cap (gold). Now
slide the two rectangular nuts on the stop body into the
alternate T-slot on the cap. (See Fig. 7) Tighten the two
clamping knobs.
Attach the auxiliary fence as described in your INCRA
Fence ownerʼs manual.
INCRA Shop Stop Manual
3
First: Loosen both black thumbscrews.
Leave white thumbscrews fully
tightened if already installed on fence.
Second:
Turn micro adjust
screw clockwise to
move the stop
toward the cutter.
Turn counter-
clockwise and slide
stop body toward
micro adjust screw
to move stop away
from cutter.
Stop body
Third: Retighten both
black thumbscrews
3
/
4
" wooden
auxiliary fence
FIG. 5
Micro adjusting
FIG. 6
Expanded clamping mode
Shop Stop
shown in expanded
clamping mode
Stop
body
Loosen black thumbscrews
and slide stop body off of cap
Large gap
Reassemble stop body
to stop cap as shown
Standard Mode
Expanded Mode
FIG. 7
Converting from standard to expanded clamping mode
Stop cap
Note:
For auxiliary fence applications where
incremental use of the Shop Stop is required, use
3
⁄
4
" hardwood or plywood and make sure that the
auxiliary fence is no taller than your INCRA Fence.
Stop cap
Small gap
Содержание Shop Stop
Страница 1: ......