Number of
flashes
Make of head unit
1
Clarion (Default)
2
Kenwood
3
JVC
4
Alpine
6
Pioneer (Set jumper)
7
Sony
To reprogram the interface for another head unit make
1.
Disconnect the interface from the 14 Pin connector.
2.
Push the reset button in and keep it pushed in.
3.
Reconnect the interface to the 14 Pin connector
4.
The LED will flash green then go off.
5.
Release the reset button.
6.
The LED will flash red then green.
7.
Use Vol+/- to set the amount of flashes
8.
Confirm selection with Seek +
To reset the interface (if installing into another vehicle)
With the interface powered, press and hold the rest button. When the LED goes off,
release the reset button. The LED will go to green and the reset is complete.
[email protected] 01392 829435 In Car Tec, 2 Leigham Units, Marsh Barton, Exeter, EX2 8HY
Setting the jumpers
There are a series of jumper pins on the interface board. These may need to be changed
depending on the head unit you are fitting or the type of outputs you require.
1 2 3
J1
J2
J3
J4
J5
JUMPERS
1 - 2
2 - 3
J1
ALPINE - SONY OUTPUT
PIONEER OUTPUT
J2
GND BRAKE OUTPUT
POSITIVE BRAKE OUTPUT
J3
GND REVERSE OUTPUT POSITIVE REVERSE OUTPUT
J4
BLAUPUNKT
DO NOT USE
J5
K-BUS HANDLING
CAN-BUS HANDLING
