Inbeca MF 22, Руководство по эксплуатации и обслуживанию

Страница: 26 / 39

NOTE: Use only foot fat or water repellent for the upper ball bearing of the
evaporator.
Check the quality of the ice.
NOTE: It is usual that with the ice come out a little of water.
The ice come out from the outlet too wide, but, letting it in the storage, lose
the excess of water.
¾
INSTRUCTIONS TO CLEAN THE WATER CIRCUIT
1.
Swith off the unit whit the general switch.
2.
Put below the outlet of ice (two in models MF61) some tanks to pick up the
ice mixed with the descaling solution that it is produced to avoid that the
storage ice get contaminated with the descaling solution.
3.
Close the stopcock of water in the supply line.
4.
Take out the upper panel to get the float tank.
5.
Take out hte float tank and connect with electric cables the two bars of
water level sensor supplying low tension.
NOTE. Not support one or both bars of water level sensor in the body othe
unit, because, in this way, the condenser sensor transmit tension to the
electronic board, making the unit to stop due to a high temperature.
6.
Disconnect the inferior extrem of the tube that conect the float tank with the
evaporator and pick up with a recipient the water, after it connect it again.
7.
In a clean bucket prepare the descaling solution diluting 2-3 liter of warm
tap water (45-50°C) with 0.2-0.3 litros de desincrustante
ATTENTION: The descaling product for ice equipment, contains
phosporic acid and hidroxiacid. This solution is corru Dicha solución es
corrosive and in case of ingest can produce intestinal damage. Do not
provoce vomiting. In this case it is necessary to drink a lot of water and
milk and go directly to the doctor. In case of external contact it is
enough with cleaning the are with water. KEEP OUT OF CHILDREN.
8.
Pour the descaling solution in the tank float, after that give current to the
unit connecting the external switch.
9.
Wait until the unit start to work to continue pouring the descaling solution
trying to mantain the level below the top tube.
NOTE: The ice produced with the descaling solution it is presented yellowish
and soft. In this phase it can be produce strong creaking in the evaportaion
due to the rubbing between the ice and the surface of the evaporator.
In this case it is recommended to stop the unit during some minuts so as to
the descaling solution can dissolve the lime inside the evaporator.
10.
Once it is finished the descaling solution, open the stopcock and make to
work the unit until the ice will be again compact and clean.
11.
Stop again the unit and dissolve the ice produced pouring some bottles of
warm water inside the container; then with a sponge with antibacterial product
clean the inner walls of the container. Take out the electric cables of the water
level sensor and install again the lid of the tank float, then install again the
upper panel.
ATTENTION: Do not use manufactured ice produced with the cleaning
solution.
NOTE. Remember that for avoiding bacterial accumulation you have to clean
the inner area of the container every week with an antibacterial solution
diluted with water.
24