9
Figure 4-5
2. Enter VUH Local IP, Subnet Mask and Gateway.
3. Press OK.
Now device interface shows
at the upper right corner which means wired connection
is successful.
Note:
You also can enable DHCP to auto gain VUH IP, subnet mask and gateway and
press OK to complete wired connection.
Step 5. Press Production to config VUH room no.
Warning:
VUH room no. must match VUH short no. on WEB of corresponding VUO. Please
refer to Ch 5.2.3.
If you want to set this VUH to be master VUH, then you shall select
Master. Fill in room no., press OK to save, see Figure 4-6.