Inalto IGGC60, Руководство пользователя, Страница: 15 / 24

PAGE 15
GAS TAP MAINTENANCE
IMPORTANT! The installation must be carried out by a suitably qualified and licensed gas fitter and in accordance
with the current standards.
WARNING! Before carrying out any maintenance operations, always isolate the cooktop from the electricity and
gas supplies.
If a gas tap becomes stiff to operate, then you should proceed as follows:
► Remove the control knobs, pan supports, burners, hob fixing screws and clamps.
► Remove the hob from the worktop and remove any underside protective covers.
► Disconnect the fixings holding the tap to the fascia panel and separate the assembly. Then clean the cone and seating,
with a cloth dampened with solvent.
► Lightly smear the cone with high temperature grease, reassemble into position and rotate a few times.
► Remove the cone again and remove any excess grease, making sure that the gas ducts are not obstructed with grease.
► Carefully reassemble the components and perform a gas soundness test.
If it becomes necessary to replace a gas tap, then you should proceed as follows:
► Remove the control knobs, pan supports, burners, hob fixing screws and clamps.
► Remove the hob from the worktop and remove any underside protective covers.
► Disconnect the fixings holding the tap to the fascia panel and separate the assembly.
► Disconnect the gas pipe from the gas tap, and then disassemble them from the gas rail by removing the fixing screws.
► When fitting a new tap, ensure that a new gasket is used.
► Reconnect the gas tap, perform a gas soundness test, and then reassemble the hob.
ELECTRICAL CONNECTION
IMPORTANT! The installation must be carried out by a suitably qualified and authorised person and in accordance
with the latest edition of the AS/NZS 3000 Wiring Regulations and in compliance with the instructions
outlined within this user manual.
WARNING! 240 Volts. Disconnect power before servicing the cooktop.
Before connecting the appliance, make sure that the supply voltage marked on the rating plate corresponds with your
mains supply voltage.
► Cable type: H05 RRF 3 core x 0.75 mm³ (Type RR-F <HAR> marked).
► The mains supply cable is supplied with this product.
If the mains supply cable is damaged, then it must be replaced by an appropriate replacement, which can be obtained from
Residentia Group, or an authorised service agent.