Inalto IF9EG, Руководство пользователя

Страница: 23 / 28

PAGE 23
TROUBLESHOOTING
& TECHNICAL DATA
PROBLEM POSSIBLE CAUSE WHAT TO DO
Oven or grill not working Power not turned on. Switch on electricity
Household fuse blown Check fuses
Controls incorrectly set Reset controls
Circuit breaker tripped Check circuit breaker
Clock not set Set time of day on timer
Oven not heating enough
Foil or trays on bottom of oven Remove foil or trays
Light and fans on continuously Timer not in manual mode Set timer to manual mode
Oven not working Timer not in manual mode Set timer to manual mode
Household fuse blown Check fuses
Oven light not working Household fuse blown Check fuses
Circuit breaker tripped Check circuit breaker
Lamp blown or loose in socket Replace or tighten lamp
Cooker smoking when first used Protective oils being removed Turn grill on high for 30 mins and then
the oven on 220°C for 1 hour
Too much condensation
building up when baking
Too much water used when cooking Reduce amount of water
Leave oven door open after cooking
Smells when first using oven Protective oils being removed This is normal
Timer flashing Power failure or interruption Reset time of day
Burner will not light even Knob not held down long enough in Repeat lighting procedure and hold
though the sparker is working ‘High’ position for flame safeguard knob down for 5 sec. in High position
(where fitted) to engage
Gas supply valve turned off Turn on gas supply to appliance
Wrong knob turned off Ensure the knob you are turning
corresponds to the burner you want
to light
Port blockage in ignition area Ensure the ports in the ignition area
are clean and dry
Ignition spark plugs wet or dirty Dry or clean ignition spark plugs
No spark is obtained when Electricity supply is disconnected Switch on electricity or check fuses
control knob is activated or switched off
Ignition spark plugs wet or dirty Dry or clean ignition spark plugs
Flames uneven or tending to lift
Flame ports blocked or wet Clean or dry flame ports
Burner incorrectly fitted Ensure this component is fitted
correctly
Flames not staying on Knob not held down long enough in Repeat lighting procedure and hold
when knob released ‘High’ position for flame safeguard knob down for 5 seconds in 'High'
(where fitted) to engage position
Knob not set between ‘High’ and ‘Low’ Knob MUST be set between these
positions
Dirt or spillage on flame safeguard Clean flameguard sensor tip
sensor (where fitted)
Low heat, slow cooking Incorrect cooking pot or pan being used Refer to cooktop section for correct
selection
Benchtop or knobs overheating Incorrect cooking pot or pan being used Refer to cooktop section for correct
selection
Pot or pan not located on burner Ensure pot or pan is centrally located
properly on burner