Inalto IF9EG, Руководство пользователя

Страница: 13 / 28

PAGE 13
You can find control buttons in the diagram below. With these control buttons power of each heating element can
be adjustable. Buttons can turn clockwise or opposite to clockwise directions. Please bring the control button to
required cooking position. For first cooking, it recommended to use highest cooking position.
User Instructions :
Before start cleaning cooker be sure that electrical connection is and gas connection are cut off.
Please do not use rough pots can scratch the surface of cooker. Before using cooking pots, pay attention that their base is
dry and clean. Base diameter of cooking pots must be same as cooking surface of cooker. Base of cooking pot must be a
little concave in cold condition. When this concave base heated, its contact with cooker surface increases by expansion;
so maximum heat transfer from cooker to pot provided. Best base thickness for enamelled pots is 2-3 mm. For sandwich
type stainless steel pots 4-6 mm base thickness is recommended. To test whether pot base has right shape or not, you can
do this easy test when it is cold as follows : Let pot base stay contacted to smooth side of desk in right, pass it on between
some paper tape. (For enamelled pot 5-10 pieces of paper tape, for stainless steel pot 2-5 pieces of tape are recommended).
USING THE HOB
Before using the cooker for the first time you should:
► Read the operating and safety instructions thoroughly.
► If applicable, remove the remnants of stickers and glue from the surface of the hob, pan supports and oven door.
► Ensure that all elements of the burners are positioned correctly.
► Press and turn the control knob to the large flame position.
Press and hold the ignition button downwards until ignition
has started (Fig. 5).
► The large flame mark is for maximum heat output.
► For simmering, lower the heat output by turning the control
knob towards the smaller flame position.
► Turn the knob to OFF ( ) when cooking has finished.
► The flame should not lick around from the bottom of a pan
but cover only two-thirds of its surface. This will reduce the
gas consumption and prevent the flame from soiling the
utensils.
► The size of the flame depends on the position of the knob.
The full flame should be used until the dish begins to boil,
then it is better to use the simmering flame.
► Burners and ignitor tips should be kept clean, as dirt
adversely affects the performance.
► Before removing an item off a burner, reduce the flame or
turn the burner off completely.
► Before switching on a burner, make sure that the knob you
are going to use corresponds to the burner you wish to
switch on. The relationship between knobs and burners is
shown in Fig. 5.
75
50
100
125
15
0
20
0
250
18
0
Max
0 0 0 0 0
STOP
Thermostat Timer Hob Knobs
Cooking Functions
OPERATING YOUR COOKER
0
OFF POSITION
LARGE FLAME
SMALL FLAME
FIG. 5
FRONT
LEFT
BACK
LEFT
CENTRE BACK
RIGHT
FRONT
RIGHT