Inalto IDO68S, Руководство пользователя

Страница: 8 / 20

USER MANUAL PAGE 08
Installation Continued
Ensure that the appliance is switched off before replacing the lamp
to avoid the possibility of electric shock.
WARNING
Check that the power rating of the mains supply and of the
sockets to ensure they are suitable for the maximum power of the
appliance as indicated on the rating plate.
¬ If a plug comes with the appliance it should be accessible after
installation.
¬ Ensure that the plug is fi tted into an earthed socket.
¬ If the appliance has no plug and cord hard wiring is undertaken
as follows:
○ The “yellow/green” earth wire, must be connected to the
terminal fi rst and be about 10mm longer than the neutral
“blue” wire
○ The neutral “blue” wire has to be connected to the terminal
marked with letter N.
○ “Black, brown, red” live wire/s have to be connected to
terminal L.
○ Mains connection can also be made by fi tting a double
pole switch with a minimum gap between the contacts of
3mm, proportionate to the load and complying with the
regulations in force.
The yellow/green earth wire should not be controlled by the
switch.
The plug or a double pole switch used for mains supply connection
should be easily accessible once the appliance is in position.
IMPORTANT:
¬ Position the mains supply cable so that it is never subjected
to a temperature which is more than 50� above ambient
temperature.
¬ The electrical safety of the appliance can only be guaranteed
when it has been correctly connected to an earthed power
supply, and installed as per the regulations for electrical safety.
¬ The manufacturer cannot be held responsible for any damage
to persons or objects due to an earth connection not been
used.
ELECTRICAL CONNECTION
Ovens equipped with a three-power supply cable are designed
to operate with alternating current at the voltage and frequency
indicated on the data plate located on the appliance (see below).
Fitting the power supply cable
Fig. 6
The following steps refer to Fig. 6.
1. Open the terminal board by inserting a screwdriver into the
side tabs of the cover.
2. Use the screwdriver as a lever by pushing it down to open the
cover.
3. Install the power supply cable by loosening the cable clamp
screw and the three wire contact screws L N
4. Connect the wires to the corresponding terminals the Blue wire
to the terminal marked (N), the Brown wire to the terminal
marked (L) and the Yellow/Green wire to the terminal marked
with the earth symbol.
5. Secure the cable by fastening the clamp screw.
6. Close the cover of the terminal board.
Connecting the electricity supply cable to the mains
1. Cable must be connected to power supply cable through power
switch.
2. Rated current of power switch must be higher than 16A.
3. Ambient temperature of power supply cable cannot exceed 50
degrees.
4. Once oven is installed, power switch should be cut off easily.
5. The cable must not be bent or compressed.
6. The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
You can only disconnect the appliance if a plug and cord is
installed.