8
Installation
BEFORE YOU INSTALL THE COOKTOP
• Be sure that the work surface is square and level,
and no structural members interfere with space
requirements.
• The work surface is made of a heat-resistant material.
• If the hob is installed above an oven, the oven has a
built-in cooling fan.
• The installation will comply with all clearance
requirements and applicable standards and
regulations.
• A suitable isolating switch providing full disconnection
from the mains power supply is incorporated in the
permanent wiring, mounted and positioned to comply
with the local wiring rules and regulations.
• The isolating switch must be of an approved type and
provide a 3mm air gap contact separation in all poles
(or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
• The isolating switch will be easily accessible to the
customer with the hob installed
• You consult local building authorities and by-laws if in
doubt regarding installation
• You use heat-resistant and easy-to-clean finishes
(such as ceramic tiles) for the wall surfaces surrounding
the hob.
AFTER THE COOKTOP INSTALLATION
• Be sure that the power supply cable is not accessible
through cupboard doors or drawers.
• There is adequate flow of air from outside the
cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard
space, a thermal protection barrier is installed below
the base of the hob.
• The isolating switch is easily accessible by the
customer.
CAUTIONS
• The hob must be installed by qualified personnel or
technicians. Please never conduct the operation by
yourself. Contact 1300 11 HELP (4357) for arrange an
authorised technician.
• The hob shall not be mounted to cooling equipment,
dishwashers and rotary dryers.
• The hob shall be installed such that better heat
radiation can be ensured to enhance its reliability.
• The wall and induced heating zone above the work
surface shall withstand heat.
• To avoid any damage, the sandwich layer and adhesive
must be resistant to heat.
• A steam cleaner is not to be used.
CONNECTING THE COOKTOP TO THE MAINS
POWER SUPPLY
The power supply should be connected in compliance with
the relevant standard, or a single-pole circuit breaker.
• If the cable is damaged or needs replacing, this should
be done by an after-sales technician using the proper
tools, so as to avoid any accidents.
• If the appliance is being connected directly to the mains
supply, an omnipolar circuit breaker must be installed
with a minimum gap of 3mm between the contacts.
• The installer must ensure that the correct electrical
connection has been made and that it complies with
safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and only replaced
by a proper qualified person.
BEFORE LOCATING THE FIXING BRACKETS
• The unit should be placed on a stable, smooth surface
(use the packaging). Do not apply force onto the
controls protruding from the hob.
LOCATING THE FIXING BRACKETS
• The unit should be placed on a stable, smooth surface
(use the packaging). Do not apply force onto the
controls protruding from the hob.
• Fix the hob on the work surface by screw four brackets
on the bottom of hob (see picture) after installation.
• Adjust the bracket position to suit for different work
surface’s thickness.
ICI302K
ICI603K
ICI603K