8
6.
If you require hot water early in the morning, switch "ON" the heater previous night
itself, thermostat would cut off the power automatically, when the water reaches the set
temperature.
7.
The heater can also be kept "ON" always, if required since the heater is completely
insulated, the water will remain hot. The thermostat will cut in and cut off automatically
to keep the water at constant temperature. In this way you can have hot water always.
Maintenance & cleaning
1.
To benefit from the highest standards of service and to ensure your guarantee remains in
focus, please always contact INALSA approved dealer or INALSA Authorised service
franchise.
2.
Always keep the inlet control valve open.
3.
Never switch "ON" the water heater without water in the heater. It will damage the
heating element.
4.
Check condition of metal flexible pipe at - least once in a year. If found damaged replace
with new pipes.
5.
Check the condition of power supply cord for "No damages" Replace it by a authentic
supply cord in case of damage.
6.
To increase the life of heating element, de-scaling should be done periodically with the
assistance of the nearest authorised service center.
If the water heater is not going to be used for a long time
a) Plug Off the power supply
b) Stop inlet water supply
c) Unscrew the drain lever, lift the lever upward to remove the water through drain
system provided in MFV.
7.
During resuse of water heater
a) Ensure drain plug lever is reset and screwed
b) Open Inlet Valve and fill the water heater till the clean water flows from outlet tap.
c) Plug in the power supply to heat the water.
8.
Periodically check MFV to ensure that it is in operating condition. The MFV should be
operated regularly to remove salt deposits and to verify that it is not blocked.
9.
Check proper functioning of the safety valve in every two months by opening and
closing the test lever.
10.
The heating element should be checked every year for "No Scale Formation" caused by
impurities in the water supply.
11.
We recommend to check Magnesium anode rod every year & once it has been used up
over 60% the Magnesium anode should be replaced with a new one.
For cleaning the element or replacing the anode :
1.
Switch off the electric supply to the water heater.
2.
Open the hot water taps until the hot water is removed completely.
Содержание PSG 15GL
Страница 1: ...Instruction Manual...
