I
n the Garage AG – Zumikerstrasse 24, Zollikon 8702 Switzerland (V. 22/3/21)
5 / 6
12.
Snap on the corresponding plug Adapter for your region onto the
AC Adapter
13.
Plug the
AC Adapter
in an appropriate electrical power socket
14.
Outdoor version: Install the
Fan Cover Support
inside the hood above the fans
15.
Outdoor version: Anchor the device to the ground (refer to
Warnings & Care
for more information)
16.
Close all zippers to allow the air to circulate properly
Note: when new, you may experience some “sticky” zippers. Do not force them. We recommend using
two hands to open/close zippers (one inside and one outside). Also, it is easier to close zippers when
the Fans are not running.
Deflation
1.
Unscrew the cover inserted in the side marked "Deflate" from the pump
2.
Connect one end of the
Air Hose
to the Deflate Side of the
Air Pump.
Remove the
Maintenance
Nozzle
and replace it with the
Deflation Nozzle.
3.
Disconnect the
Pressure Adapter
from the upper valve marked “(1) Inflate/Deflate” on the Ultimate
Car/Bike Shield
4.
Insert the
Deflation Nozzle
in the upper valve marked “(1) Inflate/Deflate”
5.
Turn on the
Air Pump
using the red 0/1 button and the Ultimate Car / Bike Shield will deflate in less
than five minutes. You can eventually help by pressing the inner tab of the upper valve "(1) Inflate /
Deflate"
N.B.:
•
You may need to assist the device by lifting the pillars during deflation
•
If it is not fully deflated at five minutes, turn off the pump and unfold any portions which may be
“stuck”
