18
Figure 3.11 Placing the screw in the enclosure
Figure 3.12 Securing the screw to the DIN clip
Placing Dome Connectors and Plugs in the Enclosure
When installed as directed, this product is rated IP-67 and can withstand temporary immersion in up to 1 meter of water. To
meet the IP-67 rating, the following conditions must be met.
l
The lid must be completely closed and screwed down.
l
The 6 ports must be plugged with either cord grips and cables, port plugs, or a combination of both.
l
Additionally, O-rings must be used as described below.
Attach plugs and dome connectors to the enclosure using the following steps.
1. Place a large O-ring over the threaded end of the plug or dome connector.
2. Screw the threaded end of the plug or dome connector through the bottom of the enclosure. Tighten it to “snug” and
then an turn it an additional half turn.
Do not over tighten.
3. Inside the enclosure, place the lock nut, concave-side-down, over the threaded end of the plug or dome connector
and tighten with a flat-head screwdriver and mallet. Tighten the lock nuts so that there is approximately 1 thread
showing above the nut.
4. Screw the dome nut onto the threaded connector. Tighten it to “snug” and then turn it an additional half turn.
Содержание Con TROLL PRO AC
