EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
This fixture can be set into the ground or built into various sorts of
decorative paving, such as concrete or natural stone, or wooden con-
structions such as decking, etc.
Step 1
To fit into wood, use a suitable saw for cutting holes with a diameter of
100 mm / 3.9 inches. If working with stone or similar materials, use a
diamond drill bit. These are available from your dealer. Drill holes
where appropriate before beginning to fit the fixture. (Fig. 1)
Step 2
Slide the mounting ring onto the fixture (Fig. 2). Feed the connector for
the fixture through the hole and then carefully insert the fixture into the
recess.
NB: If the hole is too small you can cut a bit off each of the ribs.
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 3)
a. There are two cable ducts. The duct with the narrowest slot is suit-
able for the 14/2 and 10/2 main cable. When using the old (thick)
10/2 cable, you should use the duct with the wide slot.
b. Clamp the correct cable duct on top of the main cable. There
should be no space left between the cable and the duct.
c. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
d. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Install the Easy-Lock directly below the hole in the sand bed. That way
you can easily reach it whenever necessary.
Step 5
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 4) If the lamp does not work correctly, check that the
Easy-Lock connector is properly connected to the main cable. Do the
same for the mini-connector. Repeat steps 3, 4 and 5. When the fixture
is connected to the main cable also check that the contacts of the
Easy-Lock connector are not bent. If you have any problems, contact
your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
