IMV AlphaVision, Инструкция по эксплуатации

Страница: 13 / 24

www.imv-imaging.com | 13
LED indicators
The AlphaVision has 2 LEDs on the front keymat. •
LED sequence Power LED Wi-Fi LED
Blue Flashing Device turning on
AlphaVision searching for
available viewing device
Blue
Device on and battery between
66-100% charge
Connected to AlphaVision
Yellow
Device on and battery between
33-66% charge
-
Yellow flashing
Device on and battery between
0-33% charge
-
Both LEDs flashing Yellow Updating Firmware Updating Firmware
Power
button
Power
LED
Wi-Fi
LED
Operating
instructions
Image and
video capture
button
Buttons
The AlphaVision has 2 buttons on the keymat.
Power button - one long press (2-3 seconds) will turn the device on. Repeat this to turn the device off.
Image and video capture button - A single press will take an image. A longer press will start a video
capture, a further single press after this will stop the video capture. Images and videos can only be
saved if a tablet or phone is connected to the AlphaVision. •
Your AlphaVision can be reset to factory
firmware settings in the unlikely event the device
fails. Hold down the power and Image capture
buttons until both LEDs glow yellow and release.
This will take a few minutes and the scanner will
then switch off – removing the license from the
AlphaVision Wifi.
Factory reset