23
PULSEMIG 270-T1 / 270-T2 / 300
EN
ONLY FOR THE PULSEMIG 270-T2
The Spool Gun torch is connected to the connector (7). This torch can be
used only in synergic, standard and manual mode.
- In manual mode (see p.20), the knob to adjust the wire speed is on the
torch (adjustment cannot be done on the machine).
- In synergic mode (see p.20), the adjusting knob enables to amend the
wire speed between 50% to 100% of the interface value.
The detection of the Push-Pull torch is made by a simple press on the trig
-
ger. Make sure to adjust the max speed wanted with the dial on the inter
-
face.
Spool Gun torch (OPTION)
Procedure of reel assembly on
Spool Gun torch
4
5
1
2 3
1- Button opening/closing casing
2- Reel tightening nut
3- Reel break nut (do not tighten too much)
4- Adjsutment screw for rollers tension
5- Adjustment knob for speed wire
- Open the case (1), remove the support nut (2).
- Untighten the reel brake nut (3).
- Insert your reel.
- To insert the wire in the rollers, put a tension on the «adjustment screw for rollers
tension (4)»
- Remove the torch wire by reeling the reel.
- Plug in the Spool gun command connector and power connector (see p.2).
RESET
The PULSEMIG has 2 reset options. The « SOFT » option resets the machine
completely but stores the settings saved in memory. The « TOTAL » option
reset the machine perameters to those when purchased (For this mode an SD
card is needed).
Save:
To save a welding program you need to enter a number and a name. (7
letters) In the event of use with several torches, select the torch used before
getting back the memory.
SD card with version V1005 allows using synergic welding for the material and diameters in the chart below:
