ENVIROTECH ALARMS - IMRITA - INSTALLATION INSTRUCTIONS - VERSION 1.0
Wireless E-water APP for Water Leak Detector interface
Tells you that there is
a leak and the valve
has closed.
Tells you that the
status of the valve is
open.
Clicking on the Open
button will open the
valve if it is closed.
Tells you that the
status of the valve is
Closed.
Clicking on the Open
button will open the
valve if it is closed.
Tells you that the
status of the battery
in one of the remote
sensors is low.
Clicking on the gear wheel in the top right hand corner will take you
into the set up page. Here is a handy way to set and edited all the
parameters:
Volume - The amount of water in litres allowed to flow in any one
continuous session.
Water Time - The amount of water in minutes allowed to flow in any
one continuous session.
Leak Time - The amount of time water can flow at a slower flow rate,
used to detect smaller leaks.
Automatic Water Restore Time - The length of time before the valve
will automatically reopen after a
leak has been detected, if a valve or
tap is not closed.
Automatic valve closing - The length of time in days when the valve
will automatically close if there is no flow
detected.
Valve test - The length of time in days when the valve will
automatically self test (open, then close).
To set or edit any of the parameters click on the number you want to change. The numeric
keypad will show on your device. Delete the current setting and type in the new one. Click on
save settings when you have finished. the new settings are now the current numbers used by
the Imrita smart home water leak detector.
