IMR® 2800
34
IMR Environmental Equipment, Inc.
3.5.8.3 Interface
This mode sets all the parameters for the RS232 interface.
An
IMR
Null-modem cable is needed for the data transfer to a PC.
Important:
All needed parameters must be set before a data transfer can be started.
Data can be transferred in only one format: decimal or formatted
Continuous output
Continuous serial data transfer
Output once
One measurement will be transferred
Memory
Memory will be transferred
Decimal output
Only ASCII signs will be transferred
Formatted output
Printout format will be transferred
Set parameters
Set Baud Rate
Stop output
Stops data transfer
=== Organization ===
----- Interface ----
Continuous output
Output once
Move the arrow selector up or down ("^","
v
") to select a menu
point.
Enter the menu point by pressing the "
" button.
To see the other menu points scroll with the "^" and "
v
" button.
Active buttons
Move arrow selector up
^
Back to measurement menu
ESC
Move arrow selector down
v
Confirm selection
Continuous output:
This mode starts a continuous serial data transfer from the
IMR 2800
to a PC.
====Organization====
---Interface---
Seconds/Output
10
A measurement is transmitted every ten seconds.
Using the numeric buttons changes the interval setting.
Valid intervals: 1-255 seconds
Pressing the "
" button confirms the selection
==== Organization ====
----Interface----
Minutes/Output
5
If the statistic is active, then a statistic measurement is
transferred every five minutes.
Using the numeric buttons changes the interval settings.
Valid intervals: 1-255 minutes
Pressing the "
" button confirms the selection
Continuous output
Press any key
If the statistics and print intervals are active, then a continuous
data transfer cannot be started.