Impex MARCY MXM-5, Руководство пользователя

Страница: 19 / 27

STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Attach one 124” Cable (#51) to the lower opening on the Rear Vertical Beam (#23). Attach
a Pulley to the opening. Secure it with M10 x 2 3/8” Allen Bolt (#88), two Ø 1” Bushings
(#78), and one M10 Aircraft Nut (#99).
B.) Draw the Cable underneath the Pulley to the open bracket on the Weight Glide Post (#22).
Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#86), two
∅
¾”
Washers (#82), and one M10 Aircraft Nut (#99).
C.) Draw the Cable around the Pulley then upward to the Double Floating Pulley Bracket
installed in Step-5. Install a Pulley.
D.) Draw the Cable around the Pulley then downward to the open bracket on the back of Rear
Vertical Beam. Install a Pulley then draw the Cable upward to the Single Floating Pulley
Bracket installed in Step-6. Secure the end of the Cable to the bracket with M10 x 1” Allen
Bolt (#85), two
∅
¾” Washers (#82), and one M10 Aircraft Nut (#99).
E.) Connect the Shiver Bar (#41) to the Cable with a Chain (#80) using two C-clips (#77).
F.) Check the tension of the Cables. If the Cables are too loose, adjust the tension by moving
up the Pulley on the Double Floating Pulley Bracket (#35). If the Tension is too tight, then
move down the Pulley.
18