Impex Competitor CB 610, Руководство пользователя

Страница: 7 / 14

STEP 2 (See Diagram 2)
A.) Connect the Front Stabilizer (#42) to the Main Seat Support (#52). Secure them with
two M10 x ¾” Hex Bolts (#46), four
∅
¾” Washers (#3), and two M10 Aircraft Nuts (#4).
DO NOT tighten the nuts and bolts yet. Thread the Knob Bolt (#47) into the nut on the
Front Stabilizer.
B.) Connect the Main Seat Support (#52) to the open bracket on the Cross Brace (#11).
Secure the rear hole on the bracket with one M10 x 2 3/8” Bolt (#2), two
∅
¾” Washers
(#3), and one M10 Aircraft Nut (#4). Secure the other hole with a 3” Short Lock Pin
(#58). Note: DO NOT over tighten the nut and bolt. The Main Frame needs to pivot on
this bolt in able to fold up the bench.
C.) Connect one end of Diagonal Support (#43) to the Main Seat Support (#52). Secure it
with one M8 x 2 1/8” Hex Bolt (#48), two
∅
5/8” Washers (#21) and one M8 Aircraft Nut
(#49). Connect the other end to the Front Stabilizer. Secure it with one M8 x 5/8” Hex
Bolt (#20) and
∅
5/8” Washer (#21).
D.) Securely tighten all the nuts and bolts previously installed.
E.) Insert a 6 ½” Long Lock Pin (#53) into the hole on the Main Seat Support (52). NOTE:
The Pin is not designed to sustain any heavy weight. Only use the pin when changing
the backrest board to a vertical position when doing Walk-in-Squat from the rear.
6